Nsi-industries DGUM-A Series Manual do Utilizador

MLI-201(B)INSTRUCTION MANUALDIGITAL TIME SWITCH7 DAY WITH INPUTDGU-A SERIESDGUM-A SERIESDGLC-A SERIESFOR TECHNICAL SUPPORT: 888.500.4598LISTED888

8Press the EVENT key once (or twice for two channel units) to activate current schedule then EVENT keyagain to return to AUTO mode.7.0 TO SET SUNSET A

9NOTE: A + sign will turn load ON that many hoursand/or minutes after sunset. A - sign will turn loadON that many hours and/or minutes before sunset.T

108.1 USER-SELECTED TIME ON AND SUNSET OFFPress MODE until SCH 01 appears. Press ENTERuntil a blank schedule appears then press CH1/CH2to select chann

119.0 REVIEW, MODIFY AND DELETE Press MODE to advance to any of the following MODES: 1. AUTO MODE: In this automatic mode, the unit

123. CLOCK MODE: Press HOUR and MIN to modify existing settings. Press ENTER to save changes. 4. DATE MODE: Press MONTH, DATE and YEAR to

13 Now Press ENTER briefly and everything in the timer memory is cleared and 12HOUR will flash. 4. A “PF” on the display indicates a Power

14 3. Time ON and Time OFF: Program the channel for an ON event and an OFF event for the times you choose. Do not connect a photo

15 exceed the length shown in the chart above. Calibrate per instructions below. The other terminal block, TB2 is used as remote ov

16is for timer function only

17 The Light Level dial adjusts the foot-candle (fc) set point for the control to turn ON. The load will be turned OFF and continue to h

TABLE OF CONTENTS Section Page Installation Instructions and Capabilities ...

18Two channel front panel controls are use if photo sensor EPC-A (included with DGLC200A) is connected. Each channel has a switch to set its independe

19DGU100A/DGLC100ADGUM100ADGLC200A120/277VAC120/277VAC120/277VACDGU100A/DGLC100ADGUM100ADGLC200A120/277VAC120/277VAC120/277VACDGU100A/DGLC100ADGUM100A

20

21

22

23

888.500.4598 • www.nsiindustries.com

1TORK MODEL DGU-A/DGUM-A/DGLC-A SERIES7 DAY DIGITAL TIME SWITCH WITH INPUTREAD INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL TIME SWITCH. SEE WA

2FEATURES Daylight saving - Automatic (user selectable) Leap year - Automatic compensation Power outage - Permanent schedule retention. Su

3 and minutes. Check AM/PM, and press ENTER.3.0 DATE SET MODE Press MONTH, DATE, and YEAR key to advance to the desired month, date and y

44.1 TO MODIFY STANDARD USA DAYLIGHT SAV-INGS DATES NOTE: The first two digits represent the month and the second set of digits represent

55.0 HOLIDAY DATES You are able to select up to 9 holiday blocks, which will exclude all of the regular schedules, and execute a special

6 For a single day holiday, press the ENTER key (OR) Press the MONTH, and DATE keys to set the date to the desired end date (H1

7 Note: Selection #12 will only show if a holiday date has been entered in step 5. Press ENTER to save. Follow the same procedures