INSTRUCTION MANUALMLI-206(A)365 DAY DIGITAL ENERGY & LIGHTING CONTROLELC78ELC712FOR TECHNICAL SUPPORT: 888.500.4598A DIVISION OF NSi INDUSTRI
8 Note: The off cycle is programmable from 1 second to 23 hours, 59 minutes and 59 seconds. The control will not allow an off cycle of 0
9ALBANY, NY 43 N DALLAS, TX 33 NALBUQUERQUE, 35 N DENVER, CO 40 NAMARILLO, TX 35 N DES MOINES, IA 42 NANCHORAGE, AK 61 N D
11 Press the PROGRAM key to go to next mode.4.0 EVENT MODE Up to 128 events can be programmed. Events can be an ON, an OFF, dUR1(duratio
12 • NONE: not used • On\d: On with off delay override (Recommended for a momentary switch closure to turn the load ON with a
13 Program hours, minutes, or seconds. For flashing channel number, use the + and - keys and show YES to select the channel the input will
14 Calibrate to adjust sensor input. Zero is default. F: -12,-11,-9,-8,-6,-5,-3,-2,0,2,3,5,6,8,9,11 C: -8,-7,-6,-5,-4,-3,-2,-1,0,1,2,3,4,5
15 For flashing day, use the + and - keys and show YES to select day. Press the NEXT key to advance. Move through all days and holiday A,
16 Day of Week type: Up to 10 day of week type holidays can be programmed. Each of the 10 holidays can either be assigned as one of the
177.2 SET SINGLE DAY (DATE) HOLIDAYS Press the + to bypass. Press the NEXT key advance. Use the + and - keys to modify the flashing item.
TABLE OF CONTENTS Section Page Installation Instructions and Capabil
187.4 SET BLOCK (SPAN) HOLIDAYS Press the + to bypass. Press the NEXT key advance. Use the + and - keys to modify the flashing item. Us
19 Press the +/- keys to select a channel. The current event for this channel is shown below the channel # (e.g. ON, OFF, dUR2, CYC4, SC
20LO F sensor, F sensor value below range025C sensor, C sensor valueHI C sensor, C
21Input Configurations:
22
23
24Holidays (Special):
25Holidays (Date):
26Holidays (Day of Week):
27Holidays (Block):
1TORK MODEL ELC78 EIGHT CHANNELELC712 TWELVE CHANNELENERGY AND LIGHTING CONTROLREAD INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO INSTALL TIME SWITCH. S
28
A DIVISION OF NSi INDUSTRIES, LLCUSA • 800.321.5847 • www.nsiindustries.com
2 - Momentary outputFEATURES Daylight saving - Automatic (user selectable) Leap year - Automatic compensation Power outage - Capacitor
3 control will be in the RUN mode. Planning your Programming: Six common set-up choices are listed below. Review the headers required
4 3.0) ASTR – Set sunrise, sunset times and latitude 4.0) EVNT – Set ON time at 4:00pm and OFF time (example: 11:30pm) 5.0) INPT - Sk
5 Note: The ELC 78 & ELC712 will normally be configured as maintained. The momentary option is intended for use with latching relay
61.2 SET DATE Use the + and - keys to modify the flashing item. Use the NEXT key advance to the next flashing item. Set current month, date,
7 format. Use the NEXT key advance.2.2 SET STAGGER START-UP Use the NEXT key skip stagger. Use the + and - keys to modify the flashin
Comentários a estes Manuais